Delay Chips, Clock ICs

The high-performance, low-power Microchip 8-bit AVR RISC-based microcontroller combines 4KB ISP flash memory, 256-Byte EEPROM, 256B SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with compare modes, one 8-bit high speed timer/counter, USI, internal and external Interrupts, 4-channel 10-bit A/D converter, programmable watchdog timer with internal oscillator, three software selectable power saving modes, and debugWIRE for on-chip debugging. The device achieves a throughput of 20 MIPS at 20 MHz and operates between 2.7-5.5 volts.

Atmel 8-bit AVR Microcontroller with 2/4/8K Bytes In-System Programmable Flash. DIP8.

Pin-for-pin clone of the MN3207

The BL3208 B is a 2K BBD, pin-for-pin equal of MN3208.

The Sound Semiconductor DAB2130 is a pre-soldered DIP converter for the SSI2130. This board features the SSI2130 and two decoupling caps for the V+ and V- inputs. The pinout is labelled on the board and matches the QFN pinout. This adapter features a 32 pin DIP base with a .600 in. width. The pins are standard male headers so 2.54mm female headers are recommended for socketing the board.

The Electric Druid 4-KNOB FLANGE is a flanger delay clock chip that makes building a sophisticated, versatile flanger easy. It can replace the MN3102 clock chip and the associated LFO in many modulation effects, whilst providing many new features. LFO Rate, LFO Depth and Manual flanger frequency are all variable using 0-5V control voltages. DIP8.

The Electric Druid DIGIDELAY Delay processor chip is a 16-bit, 32-KHz delay processor. With the addition of a couple of SRAM chips, it can provide up to 4 seconds of delay. It allows controlling the Delay Time, Repeats, and Delay Level, plus high pass and lowpass shelving tone filters for the delayed signal. The chip uses onboard ADC/DAC, so there

The Electric Druid ENVGEN 8C Envelope Generator removes the need for a crystal and resconstruction filter. It has an output sample rate of 31.25KHz, improving the envelope table resolution, and uses a multiplying DAC for the output, which allows full analog Level CV control without any lose of resolution or calculation errors.

The Electric Druid MULTIFLANGE flanger delay clock includes an LFO with seven waveforms, including a manual mode for fixed flanger (matrix) filtering effects. LFO Rate, Waveform, and Depth are all variable using 0-5V control voltages. The chip outputs a biphase clock from 25KHz to 500KHz that can drive MN32xx-series delay lines directly. DIP8.

The NOISE2 is a significant update to the Electric Druid original NOISE chip. Now it includes a pink noise source too, without the need for external pinking filters.

The Electric Druid PENTANOISE is a five channel digital noise source that produces independent pure white noise over the whole audio band. With only two resistors and two capacitors on each output, you can build five independent channels of analog white noise. DIP8.

The Elec Druid TAPLFO 2D chip generates a number of PWM LFO waveforms that can be used in stompboxes and synth applications. DIP14.

The Elec Druid TAP LFO 2D (SOIC) chip generates a number of PWM LFO waveforms that can be used in stompboxes and synth applications. SOIC.

The Electric Druid VCLFO 10 is a simple-to-use 0-5V voltage-controlled LFO chip with many more features than your average LFO. For a start, it can produce 16 different waveforms, in two banks of eight, including a wandering random wave and a noise source. Waveforms can be further shaped by the Wave Distort feature.

Holtek Chorus/Vibrato chip for robot voice and pitch shifter circuits. 18-pin DIP

Holtek Echo Processor. DIP16.

20 seconds of record and playback for custom loopers. DIP28.

60 seconds of record and playback for custom loopers. DIP28.

BBD, 1024 stages, DIP8. Made by XVive.

256 stage low noise BBD. Wide dynamic range and low distortion characteristics. The MN3009 provides a signal delay of up to 12,8msec and is particularly suitable for vibrato or chorus effects. Made by XVive.

Clock Generator, Driver 5V
vintage, obsolete, NOS

BBD, 1024 stages
vintage, obsolete, NOS

True bypass switching, controllable by other Pedalsync chips or 3.3V or 5V logic signal. Includes the PCB, jacks and all parts.

NE555 Timer NMOS DIP8

compander DIP16

compander DIP16

Microchip PIC10F200-I/P. 256x12 Flash 4I/O 4MHz DIP8.

Microchip PIC12F675-I/P. 1Kx14 Flash 6I/O 20MHz DIP8.

Princeton digital delay/echo IC

Princeton PT2399 digital delay/echo IC, DIP16

SA571 N compander DIP16

The Spin Semiconductor FV-1 is a complete reverb solution in a single IC. With integrated stereo ADC and DACs, the FV-1 can be treated like any other analog component in your products signal path.

The FatKeys SSI2162 provides two independent VCA channels, and like its SSI2161 and SSI2164 siblings offers great flexibility in design of dynamics processors, automatic or remote level control, and voltage controlled filters. Highly compact 10-lead SSOP package.

Based on the new Sound Semiconductor OTA circuit, the ProCircuit SSI2190 mixes six inputs into a single high compliance output. Each channel has differential voltage inputs with current-mode linear control. In addition to the obvious signal mixing, the SSI2190 can be creatively employed for phase correction, voltage controlled equalizers, pole mixing, and whatever else you can dream up.

NOS Bucket Brigade delay line for analog signals. 512 stages.