Positiv 20, 200ml

Used to manufacture printed circuit boards. 200ml spray can. Directions are included with every spray can.

Directions: Clean Board, then coat it. Let lacquer dry. Expose to UV light (340-420nM). Develop with thinned sodium hydroxide solution. Etch with Ferrum-III-Chloride. Remove rest of lacquer with acetone.

Product Safety

Signal word (CLP): Danger
GHS02 GHS07
Contains: n-butyl acetate; 1-methoxy-2-propanol; monopropylene glycol methyl ether; 2-methoxy-1methylethyl acetate; 1-methoxypropyl acetate-2; acetone; propan-2-one; propanone

Hazard statements: (CLP):
H222 - Extremely flammable aerosol.
H229 - Pressurized container: May burst if heated.
H319 - Causes serious eye irritation.
H336 - May cause drowsiness or dizziness.
H412 - Harmful to aquatic life with long lasting effects.

Precautionary statements (CLP):
P102 - Keep out of the reach of children.
P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 - Do not spray on an open flame or other ignition source.
P251 - Do not pierce or burn, even after use.
P261 - Avoid breathing vapours/spray.
P271 - Use only outdoors or in a well-ventilated area.
P280 - Wear protective gloves/eye protection.
P410+P412 - Protect from sunlight. Do not expose to temperatures exceeding 50°C.
P501 - Dispose of contents/container to a collection point for hazardous and special waste in accordance with local, regional, national and/or international regulations.
EUH066 - Repeated exposure may cause skin dryness or cracking.
Other hazards: Contains no PBT and/or vPvB substances ≥ 0.1%, assessed according to REACH Annex XIII.