Home > Electronic Parts > Tools > Painting, Colorization > Instrument Lacquer > NitorLACK Paint Remover/Stripper Gel - 1L Can N920032104

NitorLACK Paint Remover/Stripper Gel - 1L Can N920032104

NitorLACK Paint Remover/Stripper Gel - 1L Can N920032104
 
(0 reviews)  

Paint remover/stripper gel - 1L can
Colourless solvent-based stripper gel with high stripping power. It does not contain acid or alkaline products and therefore respects the painted surface, not causing corrosion in metal or altering the colour of the wood. Due to its special thixotropy it does not drip.

It is applied with a brush in thick films of the product, leaving it to act between 5 and 15 minutes. Afterwards the attacked and dissolved mass is eliminated using a spatula. IT SHOULD NEVER BE APPLIED WITH A SPRAY GUN.

If the paint to be removed is a very hard or old, it is advised to grate/bruise it by making lattice cuts before application and repeat this operation several times. This allows the product to attack and dissolve the layer or layers of paint slowly.

Before repainting on the stripped surface it is necessary to clean it thoroughly using a solvent, to prevent a new finish from being affected by the earlier applied stripper.
The product should not be left more than one hour applied on the surface to pickling because it will form a hard layer that might be hard to remove.

SAFETY
As it is a solvent based product it should be applied in well ventilated areas and with the necessary protective measures. Keep the containers from high temperatures and direct sun exposure. Do not eat, drink or smoke during application. In case of contact with eyes wash with plenty of clean water. Toxic by ingestion. Keep out of reach of children.

Product Safety

Signal word: Danger
This product is classified as: Highly flammable liquid. Possibility of serious adverse effects through repeated or prolonged exposure and through inhalation. Possibility of eye and skin irritation. Possibility of toxic effects for reproduction in category three. Possible harm to the unborn child. Possibility of adverse effects with symptoms of mild poisoning through inhalation. Vapors may cause drowsiness and dizziness.
Classification of the preparation: Harmful. Highly flammable.
Special hazards associated with the preparation and
safety instructions:
R 10 Flammable
R11 Highly flammable
R38 Irritating to skin
R20/21 Harmful by inhalation and in contact with skin.
R 23/24/25 Toxic by inhalation, in contact with skin and if swallowed.
R 36 Irritating to eyes.
R37 Irritating to respiratory system.
R38 Irritating to skin.
R 39/23/24/25 TOXIC: Danger of serious irreversible effects through inhalation, contact with skin and if swallowed.
R 48/20 Harmful: Danger of serious damage to health by prolonged exposure through inhalation.
R 63 May cause possible harm to the unborn child.R65 HARMFUL: May cause lung damage if swallowed.
R66 Repeated exposure may cause skin dryness or cracking.
R67 Vapours may cause drowsiness and dizziness.
S23 Do not breathe fumes, vapours or spray.
S36/37 Wear suitable clothing and gloves.
S 16 Keep away from sources of ignition - no smoking.
S 9 Keep container in a well-ventilated place.
S 51 Use only in well-ventilated areas.
Aerosol 1 H222-H229 Extremely flammable aerosol. Pressurised container: may burst if heated.
Eye Irrit. 2H319 Causes serious eye irritation. STOT SE 3H336 May cause drowsiness or dizziness.
Hazard-determining components of labelling: Acetone n-butyl acetate
Hazard statements: H222-H229 Extremely flammable aerosol. Pressurised container: may burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.

Precautionary statements:
P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of the reach of children.
P103 Read label before use.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P261 Avoid breathing vapours/spray.
P271 Use only outdoors or in a well-ventilated area.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if possible. Continue rinsing.
P312 Call a POISON CENTER/doctor if you feel unwell.
P337+P313 If eye irritation persists: Get medical advice/attention.
P410+P412 Protect from sun exposure. Do not expose to temperatures exceeding 50 °C/122 °F.
P501 Dispose of contents/container in accordance with local/regional/national/international regulations.
Additional information: Without adequate ventilation, explosive mixtures may form. Contains CAS 222716-38-3 Polyamide and fatty acid derivatives. May produce an allergic reaction. 2.3 Other hazards:
Results of PBT and vPvB assessment
PBT:Not applicable.
vPvB:Not applicable.


SKU SKU 72042
Weight 1.065,00 g
Manufacturer VALRESA COATINGS, S.A, Avda. dels Gremis, s/n. 46190, Riba-roja del Túria (Valencia) Spanien, valresa@valresa.com
Our price: 34,24
including VAT 19% , [plus shipping]
 Delivery time: 4-5 days*

Qty
There have been no reviews

Registered customers are welcome to add a review. Please log in and add your own review!
 
The website uses cookies to allow us to better understand how the site is used. By continuing to use this site, you consent to this policy. Click to learn more.